Do it yourself
Frequently asked questions about cars and motorcycles

Model: Derbi Gpr 125
Part: Carburetor

In order to replace the fuel on the Derbi GPR 125, you need to loosen the screws that fix the component to its housing, on the top of the engine block: once the fixing screws of the component have been loosened, you will also need to disconnect the fuel passage tubes that are connected to it. In this way, it will be possible to completely detach the old carburetor from its housing in order to insert the new one: the latter must be properly fixed to its seat and connected, verifying its operation.

Posted on 21 November 2024 by ScegliAuto

Video tutorial

Related tutorials

Gpr 125 In order to replace the clutch of the Derbi GPR 125, you need to loosen the screws that fix the cover located on the right side of the engine block: …
Gpr 125 To replace the exhaust pipe of the Derbi GPR 125, you need to loosen the screws that fix the exhaust terminal of the motorcycle, located near the rea…
Gpr 125 To replace the brake pump of the Derbi GPR 125, you will need to locate the component, which will be found in the rear part of the motorcycle between…

How to Replace the Engine Oil and Oil Filter on an Aprilia RSV 1000

This short video will show you how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Aprilia RSV 1000 motorcycle. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then use the appropriate tool to unscrew and remove the oil filter, replacing the cartridge with a new one as shown in the video. Finally, unscrew the filler screw and top up by pouring in the suitable oil for your engine!

Watch the video!


by ScegliAuto

More videos