Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the clutch of the Derbi ETX 125

Model: Derbi Etx 125
Part: Clutch

This video is currently unavailable

Today we will see the main instructions that will allow us to disassemble and replace the clutch of the Derbi ETX 125 motorcycle, in simple and quick steps. First, we put the motorcycle on the stand and start draining the engine oil by unscrewing the drain bolt found under the engine; then we unscrew the clutch pack screws, removing the entire kit, as shown in the video.

At this point we remove the clutch discs, installing the new original ones; then we reassemble the clutch and pour the new engine oil until reaching the maximum level mark!


Posted on 3 May 2025 by ScegliAuto


Related tutorials

How to Replace the Battery on a Derbi ETX 125?
How to Replace the Battery on a Derbi ETX 125?
Etx 125 To replace the battery on the Derbi ETX 125, loosen the screws securing the side panel located on the right side of the bike. Once this panel is remo…
How to Replace the Exhaust on a Derbi Etx 125
How to Replace the Exhaust on a Derbi Etx 125
Etx 125 In today's tutorial video, we will see how to remove and replace the exhaust on a Derbi Etx 125, following the instructions below. First, place the b…
How to Change the Engine Oil on a Derbi ETX 150
How to Change the Engine Oil on a Derbi ETX 150
Etx 125 Today you will change the engine oil as part of the regular maintenance service on a Derbi ETX 125. First, position the bike on a stand and warm up t…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Reset the Engine Light on a Yamaha Ray RZ?

To reset the engine light on a Yamaha Ray RZ, connect a diagnostic tool to the vehicle's OBD port. The OBD port is located just above the battery housing, accessible by removing the panel in the centre of the footwell. Once this panel is removed, connect the scanner and select the car model and its corresponding version. After connecting the scanner and following the tutorial steps, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos