Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Derbi Senda 50cc
Part: Engine

To remove the engine from the Derbi Senda 50, loosen the screws securing the seat and the plastics that make up the side fairings of the bike. Once all these protective components are removed, loosen the screws that secure the engine to the frame, allowing you to disconnect all the connectors attached to the relevant sensors. At this point, the engine can be extracted from its housing. After removing the engine from its location, you can insert the new block, securing it with the appropriate screws to the frame and reconnecting all the connectors.

Updated on 12 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Spark Plug on a Derbi Senda 50
How to Replace the Spark Plug on a Derbi Senda 50
Senda 50cc This operation must be performed with the engine cold. Before starting, position your Derbi Senda 50 on the side stand. Begin by disconnecting the ca…
How to Start a Derbi Senda
How to Start a Derbi Senda
Senda 50cc Before you begin, sit on the seat of your Derbi Senda. Start by inserting the key into the ignition switch and turning it fully clockwise. Next, pull…
How to Remove the Seat from a Derbi Senda 50
How to Remove the Seat from a Derbi Senda 50
Senda 50cc Before you can begin, position your Derbi Senda 50 on the side stand. Start by unscrewing and removing the bolts that secure the seat to the frame, l…

How to Remove the Rear Wheel on the BMW G650 GS?

In this tutorial, you will see how to remove the rear wheel on the BMW G650 GS, a very simple operation. First, lift the motorcycle from the central area using a stand or a jack, then undo the right nut with a 24 mm socket and the left one with a 19 mm spanner. Once done, using a Torx T40 key, unscrew the two chain tensioner bolts exactly half a turn each, until you loosen the tension. Finally, push the wheel towards the inside of the motorcycle, remove the chain from the sprocket, and extract the inner pin using a hammer.

Watch the video!


by ScegliAuto

More videos