Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video tutorial, you will learn how to remove and replace the front headlamp bulb on a Ducati Monster 696. First, unscrew the screws of the plastic cover located behind the speedometer using a Torx screwdriver; then disconnect its electrical connector and remove the front lamp, as shown in the video. Using a screwdriver, unscrew the screws of the bulb cover and disconnect its electrical connector, allowing you to release the metal spring and remove the bulb itself. Replace it with a new one, with H7 fitting, and reassemble the headlamp!

Updated on 4 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Headlight Bulb on a Ducati Monster
Replacing the Front Headlight Bulb on a Ducati Monster
Monster 696 Let's see how to disassemble and replace the front headlight bulb on a Ducati Monster, following these main instructions. First, unscrew the fixing s…
Replacing the Headlight Bulb of the Ducati Monster 696
Replacing the Headlight Bulb of the Ducati Monster 696
Monster 696 Below are the steps on how to dismantle and replace the headlight bulb of the Ducati Monster 696 motorcycle. First, place the motorcycle on a stand a…
Guide to Replacing the Front Headlamp Bulb of the Ducati Monster 696
Guide to Replacing the Front Headlamp Bulb of the Ducati Monster 696
Monster 696 Today's instructions will show you the main steps for removing and replacing the front headlamp bulb of the Ducati Monster 696 motorcycle. First, pla…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos