|
Do it yourself
| |||
| ||||
Model: Lml Star
To clean the carburettor on an LML Star, you first need to remove this part from its housing: to disassemble the carburettor, you must remove the right side panel of the scooter, near the rear wheel. Once this panel is removed, you will locate the carburettor underneath by unscrewing the appropriate fixing screws. Then, disconnect the fuel lines and completely remove the carburettor: you can now clean it with a blast of compressed air, then refit all the removed components.
Updated on 8 August 2026 by ScegliAuto
Video tutorial
Related tutorials
Star
To replace the knobs on the LML Star, remove the old ones by prising them off from the base, as there is a screw at the end that may break. Heat the …
Star
To assemble the clutch of the LML Star, first remove all the discs from its housing. Place the plate with springs at the base of the clutch, which wi…
Star
In order to replace the clutch of the LML Star, you need to loosen the casing located near the rear wheel: once the screws are removed, you can detac…
|
How to Remove the Engine from a KTM EXC 300?
To remove the engine from the KTM EXC 300, you need to take out the engine block from its housing by unscrewing the bolts that secure it to the supports. Once the engine block is removed, unscrew the bolts that secure the cylinder at the top, then proceed to remove the side casings. Underneath, you will find the piston and other internal components, such as the clutch. The necessary parts can now be replaced, and you can subsequently reassemble all the components that were removed earlier. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.064
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
