Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Here’s how to remove and replace the battery in the Ducati Multistrada 1200 motorcycle. First, place the bike on its centre stand and start by removing the rider's seat by unscrewing the bolts on the sides; then disconnect both battery terminals (positive and negative) by removing the wiring located at the top, as shown in the video. At this point, install the new battery, ensuring it has the same amperage as the original; then reassemble everything, following the video to the end!

Updated on 27 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the air filter of the Ducati Multistrada 1200?
How do you replace the air filter of the Ducati Multistrada 1200?
Multistrada 1200s The air filter of the Ducati Multistrada 1200 can be replaced by loosening the screws that secure the front cover panel located on the right side of …
Replacing the Air Filter on Ducati Multistrada 1200 Enduro
Replacing the Air Filter on Ducati Multistrada 1200 Enduro
Multistrada 1200s In this guide, you will see the main steps to remove and replace the engine air filter on the Ducati Multistrada 1200 Enduro. First, remove the rider…
How to replace the timing belt on the Ducati Multistrada 1200?
How to replace the timing belt on the Ducati Multistrada 1200?
Multistrada 1200s To replace the timing belt on the Ducati Multistrada 1200, loosen the bolts securing the side cover of the engine block: this is located on the right…

How to Reset the Engine Oil Light on a Yamaha XMax 250

This short video demonstrates the procedure to reset the engine oil light on a Yamaha XMax 250 scooter. The operation is very simple and quick; first, insert the motorcycle key into the designated slot and turn it to the first position to power on the instrument panel without starting the vehicle. At this point, you will see the light on the display; simply press the "oil change" button located at the centre of the motorcycle's speedometer and hold it until the light stops flashing. The operation will then be complete; to verify success, turn off and then turn on the instrument panel.

Watch the video!


by ScegliAuto

More videos