Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To change the motor oil of a Royal Enfield Meteor 350, park the motorcycle on a flat surface and make sure the engine is turned off and cold. Locate the oil drain plug under the engine and place a container to collect the old oil. Unscrew the drain plug with a suitable wrench and let the oil drain completely. Once finished, replace the gasket of the plug if necessary and tighten it securely. Remove the oil filter and replace it with a new one, lightly lubricating the gasket before installing it. Fill the engine with the oil specified in the manual, using a funnel to avoid spills. Check the oil level using the dipstick or inspection window. Finally, start the engine for a few minutes, turn it off, and recheck the level, topping up if necessary.

Posted on 22 December 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil of the Royal Enfield Meteor 350
How to Change the Engine Oil of the Royal Enfield Meteor 350
Meteor 350 In this guide, learn how to replace the engine oil and oil filter of the Royal Enfield Meteor 350 in simple and quick steps. First, place your motorc…
Replace Engine Oil and Oil Filter on Royal Enfield Meteor 350
Replace Engine Oil and Oil Filter on Royal Enfield Meteor 350
Meteor 350 Today, learn how to perform routine maintenance by changing the engine oil and oil filter on a Royal Enfield Meteor 350. First, position the motorcyc…
How to replace the engine oil in the Royal Enfield Meteor 350?
How to replace the engine oil in the Royal Enfield Meteor 350?
Meteor 350 In this tutorial we can see how to replace the engine oil in the Royal Enfield Meteor 350, an extremely simple and fast operation. First of all, make…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos