Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
This tutorial shows how to change the engine oil in the Royal Enfield Super Meteor 650, a very simple and quick operation to perform every 10,000 miles. First, ensure the engine is cool enough to work safely, then remove the relevant lower cover, locate the drain hole bolt, and unscrew it using a socket spanner. Allow all the oil in the system to drain out, unscrew the old filter, and tighten both the replacement and the bolt. Finally, pour the necessary amount of oil through the designated upper hole.

Posted on 5 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust pipe of the Royal Enfield Super Meteor 650?
How do you replace the exhaust pipe of the Royal Enfield Super Meteor 650?
Super Meteor 650 In order to replace the exhaust pipe of the Royal Enfield Super Meteor 650, you need to loosen the screws that hold it to its housing, on the right s…
How to change the engine oil in the Royal Enfield Super Meteor 650?
How to change the engine oil in the Royal Enfield Super Meteor 650?
Super Meteor 650 .. In this tutorial, you will see how to change the engine oil in the Royal Enfield Super Meteor 650, a very simple and quick operation... …
How to Replace the Rear Brake Pads on Royal Enfield Super Meteor 650
How to Replace the Rear Brake Pads on Royal Enfield Super Meteor 650
Super Meteor 650 You can replace the rear brake pads on the Royal Enfield Super Meteor 650 by loosening the screws that secure the caliper to the corresponding disc. …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos