Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Enfield Himalayan
Part: Battery

In this brief and simple guide, you will learn how to remove and replace the battery of the Royal Enfield Himalayan motorcycle by following the instructions below. First, place the motorcycle on its centre stand and start unscrewing the side screws of the battery cover (located on the right side of the bike) to remove it; then disconnect both battery terminals (positive and negative) to remove it from its compartment, as shown in the video. At this point, install the new battery of the correct type and with the same amperage; reassemble everything!

Updated on 4 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery on the Royal Enfield Himalayan?
How to Replace the Battery on the Royal Enfield Himalayan?
Himalayan To replace the battery on the Royal Enfield Himalayan, loosen the bolts securing the cover located on the right side of the bike, just below the seat…
How to Replace the Battery on the Royal Enfield Himalayan
Himalayan To replace the battery on the Royal Enfield Himalayan, insert the key into the designated lock to unlock the front and rear sections of the seat and …
How to Change the Engine Oil on a Royal Enfield Himalayan
How to Change the Engine Oil on a Royal Enfield Himalayan
Himalayan Changing the engine oil on a Royal Enfield Himalayan, as shown in this tutorial, is a straightforward and quick task. First, wait until the engine is…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos