Do it yourself
Frequently asked questions about cars and motorcycles
In order to adjust the suspension of the TM Racing 300, you need to locate the rear shock absorber of the motorcycle: this will be found in the internal part of the vehicle, in the area between the rear fender and the rear swingarm. Once the shock absorber is located, it will need to be adjusted by tightening or loosening the bolts located at its bottom and top: following the instructions in the manual, you can adjust the suspension and therefore adjust the height of the motorcycle according to your driving needs.

Posted on 6 December 2024 by ScegliAuto

Video tutorial

Related tutorials

Tm Racing 300 To replace the exhaust of the TM Racing 300, you will need to loosen the screws that secure the panel located on the right side of the rear fender: o…
Tm Racing 300 The replacement of the exhaust on a TM Racing 300 can be done by loosening the screws that secure the exhaust terminal to its housing, near the rear …
Tm Racing 300 To dismantle the engine of the TM Racing 300, you need to loosen the screws that secure the block within its housing, then disconnect the pipes and t…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos