Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Light of a Fiat Cinquecento

Model: Fiat Cinquecento MK 1 - Years: 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998
Part: Tail light

Video tutorial

In this video, learn how to remove the rear light of a Fiat Cinquecento and replace the bulbs inside. Open the boot lid, and using a screwdriver, unscrew the securing screws located at the sides of the light (remove the boot seal).

Disconnect the rear light from its housing once all screws are removed (disconnect the power connectors) and replace the damaged bulbs with new ones (same size and voltage). Finally, refit the light and reconnect the power connectors (refit the seal).

Test the correct operation of the previously installed bulbs.


Updated on 13 March 2026 by ScegliAuto


Related tutorials

How to Remove the Centre Tunnel of a Fiat Cinquecento
How to Remove the Centre Tunnel of a Fiat Cinquecento
Fiat Cinquecento (1991-1998 / MK 1) How to remove the centre tunnel of a Fiat Cinquecento? Start by removing the securing pins of the trim located at the bottom of the gear knob using a…
How to Remove the Instrument Cluster in a Fiat Cinquecento
How to Remove the Instrument Cluster in a Fiat Cinquecento
Fiat Cinquecento (1991-1998 / MK 1) How to remove the instrument cluster in a Fiat Cinquecento? Follow these steps for proper removal. Remove the plastic cover (trim) of the instrument …
Removing the External Wing Mirror of the Fiat Cinquecento
Removing the External Wing Mirror of the Fiat Cinquecento
Fiat Cinquecento (1991-1998 / MK 1) In this guide, we will see the steps to remove and replace the external wing mirror of the Fiat Cinquecento, following the instructions below. First,…

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos