Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Centre Tunnel of a Fiat Cinquecento

Model: Fiat Cinquecento MK 1 - Years: 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998
Part: Center console tunnel

Video tutorial

How to remove the centre tunnel of a Fiat Cinquecento? Start by removing the securing pins of the trim located at the bottom of the gear knob using an Allen key, then take off the leather gaiter of the gear lever. After removing the gaiter, unscrew the securing screws located at the front and rear of the centre tunnel with a screwdriver.

Once this is done, pull the tunnel away and disconnect any power cables. Finally, insert the new piece into the centre tunnel space and reassemble all the components of the glove compartment as they were removed earlier.


Updated on 13 March 2026 by ScegliAuto


Related tutorials

How to Replace the Clutch Cable on the Fiat Cinquecento?
How to Replace the Clutch Cable on the Fiat Cinquecento?
Fiat Cinquecento (1991-1998 / MK 1) To replace the clutch cable on the Fiat Cinquecento, lift the car using a ramp and access its underlying components. Here, you will locate the clutch…
Removing the External Wing Mirror of the Fiat Cinquecento
Removing the External Wing Mirror of the Fiat Cinquecento
Fiat Cinquecento (1991-1998 / MK 1) In this guide, we will see the steps to remove and replace the external wing mirror of the Fiat Cinquecento, following the instructions below. First,…
Instructions for Installing a Manual Fan Switch on a Fiat Cinquecento
Instructions for Installing a Manual Fan Switch on a Fiat Cinquecento
Fiat Cinquecento (1991-1998 / MK 1) In this video, you will see instructions on how to install a switch for manually activating the fan on a Fiat Cinquecento, to address potential engin…

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos