Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Brake Discs and Pads

Model: Fiat 500 312 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Brake rotors

See other generations:
Video tutorial

Remove the wheel and gently detach the caliper by removing the two retaining clips. Disconnect the electrical connectors.

Remove the caliper support bracket using a 17 mm ratchet spanner, unscrewing the two rear screws and set it aside. Using a 12 mm spanner, unscrew the two retaining screws of the disc while holding it steady.

If the disc is stuck, use a rubber mallet and tap it until it completely comes off the hub. Clean the support thoroughly with a degreasing spray. Clean the new discs before installation to remove the protective grease.

Refit the disc, aligning the fixing holes. Use new screws for fastening if possible.

Tighten the nuts in a criss-cross pattern with a torque wrench to secure it perfectly in place without play. Refit the bracket, cleaning and lubricating the fixing screws, then tighten them with a torque wrench.

Refit the caliper, pads, and wheel. The pad with the electrical connectors should be mounted facing inwards, paying attention to the direction of travel.

Realign the piston and check the pads' adherence to the disc.


Updated on 2 February 2026 by ScegliAuto


Related tutorials

Replacing Rear Brake Discs and Pads on a Fiat 500
Replacing Rear Brake Discs and Pads on a Fiat 500
Fiat 500 (2007-2021 / 312) In today’s video tutorial, you will find all the instructions and steps to disassemble and replace the rear brake discs and pads on a Fiat 500. First…
Replacing the Front Brake Pads on the Fiat 500
Replacing the Front Brake Pads on the Fiat 500
Fiat 500 (2007-2024 / 312) This guide will show you how to remove and replace the front brake pads on the Fiat 500. First, lift the vehicle and start by removing the front whee…
How to Change the Front Brake Pads on a Fiat 500?
How to Change the Front Brake Pads on a Fiat 500?
Fiat 500 (2007-2024 / 312) To change the front brake pads on a Fiat 500, start by lifting the front of the car with a jack and ensure it is well supported by axle stands for sa…

How to Replace the Glow Plugs in the Fiat Ducato 2.3 Multijet?

Glow plugs, as the name suggests, raise the temperature of the engine in diesel vehicles to allow for easier starting. The manufacturer, in this case, Fiat for the Ducato 2.3 Multijet, specifies how often they should be replaced, and a warning light will illuminate when it's time. This work is carried out under the bonnet. First, remove the upper engine cover, then lift the coil and, using a socket wrench of the appropriate size, unscrew the glow plug to remove it from the base, followed by installing the new one.

Watch the video!


by ScegliAuto

More videos