Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install Ambient Lights on the Handles of the Ford Kuga

Model: Ford Kuga C520, MK 2 - Years 2012-2019
Part: Handle

Let's see how to install ambient lights on the handles of the Ford Kuga. First, remove the handle from the inside by unscrewing the fixing screw and using a plastic spatula to remove the support. Using a small drill bit, create a small hole at the top of the handle. Use the spatula to also remove the lower handle to pass the cable through. Disconnect the window opening connector and run the LED cable between the two handles. Insert the LED into the hole you created in the upper handle. Apply a small dot of glue for better hold. You can then reattach the upper handle with its screw. Connect the LED cable to the connector, and you're done. Reattach the lower handle. Operation complete.

Updated on 23 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Install LED Lights in the Doors of a Ford Kuga
How to Install LED Lights in the Doors of a Ford Kuga
Ford Kuga (2012-2019 / C520, MK 2) Let’s see how to install ambient lights in the doors of a Ford Kuga. Use a plastic spatula to lift the handle switch; disconnect the electrical conne…
How to replace the cabin filter on the Ford Kuga?
How to replace the cabin filter on the Ford Kuga?
Ford Kuga (2012-2019 / C520, MK 2) You can replace the cabin filter on the Ford Kuga by removing the dashboard trim panel located at the bottom near the steering column: once the panel…
How do you replace the timing belt of the Ford Kuga?
How do you replace the timing belt of the Ford Kuga?
Ford Kuga (2008-2012 / C394, MK 1) The procedure for replacing the timing belt on the Ford Kuga involves opening the hood, in order to access the components located inside the engine c…

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos