Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install LED Lights in the Doors of a Ford Kuga

Model: Ford Kuga C520, MK 2 - Years 2012-2019
Part: Instrument panel light

Let’s see how to install ambient lights in the doors of a Ford Kuga. Use a plastic spatula to lift the handle switch; disconnect the electrical connector. With a very thin drill bit, make a small hole in the door at a hidden point to pass a small wire through, where a small light point will emerge, sufficient to pleasantly illuminate the interior. These are flat-headed diodes that can be purchased from various e-commerce platforms. For example, on Amazon, we found a kit of 5 pieces in various colours for £10.49 plus £2.70 for delivery with code B08LDCQR9D.

Updated on 8 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Install the Rear Spoiler on the Ford Kuga
How to Install the Rear Spoiler on the Ford Kuga
Ford Kuga (2012-2019 / C520, MK 2) This guide explains how to install the additional rear spoiler on the Ford Kuga, following the instructions below. First, move to the rear of your ca…
How to Install Roof Bars on a Ford Kuga
How to Install Roof Bars on a Ford Kuga
Ford Kuga (2012-2019 / C520, MK 2) To install roof bars on a Ford Kuga, first check the type of roof: most versions have integrated longitudinal rails. Then, position the cross bars ov…
How to Replace the Interior Light on a Ford Kuga
How to Replace the Interior Light on a Ford Kuga
Ford Kuga (2012-2019 / C520, MK 2) Let's see how to add a bright LED to the central interior light of the Ford Kuga: use a plastic spatula to pry around the edge of the light to remove…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos