Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : Front turn signal bulb replacement

Ford Focus - Video tutorial

Model: Ford Focus MK 3 - Years 2011-2018
Part: Side turn signal light bulb
Operation: Front turn signal bulb replacement

To change the front turn signal bulb, you have to remove the entire headlight assembly. At first sight it may seem a laborious operation but following the images you will immediately understand that it is a rather simple job. Once the hood is open, just unscrew the screws at both ends of the headlight, right on the inside edge of the hood. Remove the optical unit from its seat and, acting on the tab, disconnect the electrical connector. Now that you can handle the headlight without problems, remove the protective cap and remove the bulb holder through the opening by rotating it clockwise. The bulb, as you can see, should not be rotated but simply extracted. Once you have reinserted the new bulb, you just have to reassemble everything. Car Model: Ford Focus MK3 Tools Required: Flat blade screwdriver


Posted on 15 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Focus 1998-2004 - How to replace the mirror arrow bulb on a Ford Focus? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos