Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Brake Light Switch on a Garelli Tiger Cross?

Model: Garelli Tiger Cross
Part: Checks and maintenance

Video tutorial

To install the brake light switch on the Garelli Tiger Cross, you need to fit the appropriate bracket onto the bodywork, near the footpeg pedal. This will allow you to position the switch on the bracket and connect it to the wires.

These will be located beneath the seat, which must be removed to simplify the operation. Once all the wires are connected, pulling the brake near the corresponding pedal will activate the rear light.

After installation, you can refit the seat.


Updated on 29 April 2026 by ScegliAuto


Related tutorials

How to Dismantle the Engine of the Garelli Tiger Cross?
How to Dismantle the Engine of the Garelli Tiger Cross?
Tiger Cross The procedure for dismantling the engine of the Garelli Tiger Cross involves removing it from its housing at the bottom of the bike: once the fixing …
How do you take apart the engine of the Garelli Tiger Cross?
How do you take apart the engine of the Garelli Tiger Cross?
Tiger Cross The engine installed on the Garelli Tiger Cross can be removed by taking it out from its housing at the lower part of the vehicle: once the mounting …
How do you replace the rear shock absorber of the Garelli Tiger Cross?
How do you replace the rear shock absorber of the Garelli Tiger Cross?
Tiger Cross To replace the rear shock absorber on the Garelli Tiger Cross, you need to loosen the screws that secure this component to its housing: the screws th…

How to Replace the Air Filter in a Moto Guzzi Nevada 750?

In this tutorial, you will see how to replace the air filter in a Moto Guzzi Nevada 750, a very simple and quick operation. First, wait for the engine to be completely cold, then remove the seat, disassemble the chrome air intake, and subsequently the panel located under the tank. Repeat the operation on the opposite side, disconnect both the fuel hoses and the pump connector, and remove the tank itself. At this point, you can move all the cables above the airbox, open it, and remove the old filter. To install the replacement and reassemble everything, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos