Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Gilera
    3. : Stalker 50
In order to replace the transmission of the Gilera Stalker 50, you need to loosen the screws that fix the specific casing located near the rear wheel, on the left side of it: once this casing has been removed, you can identify the clutch and the variator that need to be removed from their seat by loosening the central nut. In this way, you can also remove the belt placed around them; once all these components have been removed, you can proceed by inserting the new ones and checking that everything works.

Posted on 22 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Belt and Variator on a Gilera Runner 50
How to Replace the Belt and Variator on a Gilera Runner 50
Runner 50 This guide outlines the steps to remove and replace the drive belt of the Gilera Runner 50 scooter. First, place the scooter on the centre stand and …
How to Replace the Drive Belt and Variator on a Gilera Runner 180
How to Replace the Drive Belt and Variator on a Gilera Runner 180
Runner 180 In this guide, we will see the main instructions on how to disassemble and replace the drive belt and the radiator on a Gilera Runner 180. First, pla…
How to replace the drive belt of the Gilera GP 800
How to replace the drive belt of the Gilera GP 800
Gp 800 In this video tutorial, we will see how to disassemble and replace the transmission belt of the Gilera GP 800 scooter, in simple steps. First of all,…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos