Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Gilera Runner 50
Part:

In this guide, we will see the instructions that will allow us to remove and replace all the plastic fairings of the Gilera Runner 50 scooter. First, place the scooter on its centre stand and start unscrewing all the fixing screws found under the instrument panel. Remove the lower cover, unscrewing the screws located on the footrests, as shown in the video. At this point, remove the front fairings and then the rear and side fairings, repairing or replacing them with new ones; ensure to follow the order of reassembly of the fairings!

Posted on 23 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you remove the fuel tank of the Gilera Runner 50?
How do you remove the fuel tank of the Gilera Runner 50?
Runner 50 In order to remove the fuel tank of the Gilera Runner 50, it is necessary to remove all the panels that form the front fairing of the motorcycle, so …
How to Replace the Battery on a Gilera Runner 50?
How to Replace the Battery on a Gilera Runner 50?
Runner 50 To replace the battery on a Gilera Runner 50, you need to remove the bolt that secures the square cover located on the side of the bike. Once that co…
Replacing the Fuel Tank Float on a Gilera Runner 50
Replacing the Fuel Tank Float on a Gilera Runner 50
Runner 50 This guide outlines the main steps to remove and replace the fuel tank float on a Gilera Runner 50 scooter. First, place the scooter on the centre st…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos