Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Harley Davidson Pushrods

Model: (Various brands) Various
Part: Engine

Video tutorial

The pushrods are located between the camshaft and the valves. They are secured to the engine block with four simple screws.

Unscrew these screws, then use a plastic hammer to loosen the pushrods, which otherwise will not move from their seat, and pull them out by inserting two fingers into the two holes and pushing them against the guides. Remove all damaged gaskets.

Remove the second guide by repeating the process, clean the area of the pushrods, and reinsert them in reverse order. If you are not replacing the pushrods but just cleaning them to refit the original guides, remember to insert the pieces exactly where you extracted them; do not mix them up!


Updated on 28 March 2026 by ScegliAuto


Related tutorials

Opening the Fuel Cap of the Harley Davidson
Opening the Fuel Cap of the Harley Davidson
(Various brands) Various Some users have found it difficult to open the fuel cap with the key provided by Harley Davidson, often because they did not read the attached instru…
How to change the battery of Harley Davidson key
How to change the battery of Harley Davidson key
(Various brands) Various In this video we can see how to change the battery in the remote control of a Harley Davidson. The model doesn't matter, as the functionality is the …
Replacing the Remote Battery on a Harley Davidson
Replacing the Remote Battery on a Harley Davidson
(Various brands) Various Today, you will perform a very simple task: removing and replacing the battery in the key used for Harley Davidson motorcycles. First, remove the man…

How to Replace the Handlebars on the Ducati Scrambler

This guide provides instructions on how to remove and replace the handlebars on the Ducati Scrambler motorcycle, following the steps outlined below. First, place the bike on its centre stand and begin removing the grips by unscrewing the screws and taking off the bar ends; then unscrew the handlebar mounting screws to remove the handlebars, as shown in the video. At this point, correctly install the new handlebars to ensure they are centred; then reassemble and secure the grips and side bar ends, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos