Do it yourself
Frequently asked questions about cars and motorcycles
The instructions in this guide will show us how to disassemble and replace the rear tail light and its bulb on the Harley Davidson Dyna. First, we put the motorcycle on the stand and start unscrewing the rear screws of the tail light to remove it; then we disconnect the electrical connector of the bulb to remove it, as shown in the video. At this point, we install the new stop light bulb, of the right type and with the same attachment; we insert it correctly and make the electrical connection, finally reassembling the rear tail light by tightening the screws!

Posted on 15 July 2024 by ScegliAuto

Video tutorial

Related tutorials

Dyna To replace the headlight bulb of the Harley Davidson Dyna, you will need to loosen the screws that secure the optical group to its housing: these wil…
Dyna It will be possible to replace the clutch of the Harley Davidson Dyna by loosening the transmission cover located on the lower right side of the moto…
Dyna To replace the battery of the Harley Davidson Dyna, you need to loosen the screws that secure the panel located immediately under the seat: this pane…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos