Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Holden
    3. :
  3. Colorado 7
    4. : Car stereo

Holden Colorado 7 - Car stereo

Holden Colorado 7 (2011-2023 / MK 2)
How to remove the factory radio in the Holden Colorado 7?
The removal of the factory-installed radio in the Holden Colorado requires first removing the lower part containing the three knobs that control the air …read all…
Posted on 24 June 2023 by ScegliAuto
Holden Colorado 7 (2008-2012 / MK 1)
How to enter the radio code in a 2009 Holden Colorado?
We disconnected the car radio from the battery and now it's locked? No problem, to use it again we just need to enter the radio code, a 4-digit pin that was …read all…
Posted on 1 April 2023 by ScegliAuto
Holden Colorado 7 (2011-2023 / MK 2)
How to disassemble the Holden Colorado 7 car stereo
In today's video tutorial we will see how to disassemble and replace the stock car stereo of the Holden Colorado 7, following the instructions below. First of …read all…
Posted on 25 December 2022 by ScegliAuto
Car stereo (3) Key (1) -board computer (1) Checks and maintenance (2) Cabin air filter (4) Third brake light (1) Engine oil (1) Instrument cluster (4)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos