Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
The engine oil of the Honda CBR 600 can be replaced by loosening the screws that secure the engine block protection plate, located on both sides of the vehicle. Once these screws have been unscrewed, it will be possible to detach this panel and loosen the drain plug below: in this way all the used oil that will be expelled can be collected inside a container. In this way, the top-up can be carried out by inserting the new oil through the vent located on the right side of the motorcycle's crankcase: by inserting the necessary amount of oil, it can be verified that everything is functioning properly.

Posted on 24 January 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil on a 2007 Honda CBR 600
How to Change the Engine Oil on a 2007 Honda CBR 600
Cbr 600 Rr In this video tutorial, you will learn how to change the engine oil and oil filter while performing the regular maintenance service on the 2007 Honda…
How to replace the spark plugs of the Honda CBR 600 RR
How to replace the spark plugs of the Honda CBR 600 RR
Cbr 600 Rr In this guide we will see the main instructions on how to disassemble and replace the spark plugs of the engine of the Honda CBR 600 RR motorcycle. F…
How to Replace the Clutch on a Honda CBR 600 RR?
How to Replace the Clutch on a Honda CBR 600 RR?
Cbr 600 Rr To replace the clutch on a Honda CBR 600 RR, loosen the screws securing the cover on the right side of the bike and remove some surrounding fairings.…

How to Service the Piaggio Vespa GTS 300

This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos