Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Honda
    3. : Cr 250

Model: Honda Cr 250
Part: Wheel

In this video tutorial, you will learn how to remove and fit the front wheel of a Honda CR 250. First, position the bike on a stand and remove the 12 mm bolts securing the front brake caliper; then, take off the caliper along with the brake pads and unscrew the central wheel bolt using a 22 mm socket. At this point, slide out the central axle by tapping from one side, and remove the front wheel; then, simply refit it by reversing the procedure and following the video tutorial to the end!

Updated on 7 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Wheel Bearing on a Ford F-250?
How to Replace the Front Wheel Bearing on a Ford F-250?
Ford F-250 (2011-2016 / P473) To replace the front wheel bearing on a Ford F-250, lift the vehicle with a jack so that the corresponding front wheel is off the ground. Remove the …
Removing the Front Wheel on a Yamaha Xmax 250
Removing the Front Wheel on a Yamaha Xmax 250
Xmax 250 In today's video, you will learn how to remove the front wheel on the Yamaha Xmax 250 scooter in simple and quick steps. First, position the scooter …
Removing and Replacing the Front Wheel of a Yamaha X300
Removing and Replacing the Front Wheel of a Yamaha X300
X300 Follow these steps to remove and replace the front wheel of a Yamaha X300 scooter. Start by placing the scooter on its centre stand. Use a socket spa…

Changing the Oil and Filter on the Kawasaki Versys

Here’s how to change the oil and filter on the Kawasaki Versys. Warm up the engine for a few minutes, place the motorcycle on the centre stand, open the filler cap, and remove the drain plug underneath the engine. Place a catch basin under the oil sump, unscrew the drain plug, and let the oil drain out. Unscrew the oil filter and let all the old oil drain out. Install a new filter and tighten it with the appropriate tool. Pour half a glass of new oil into the filler cap and wait for it to flow out of the drain hole, after which replace the plug. Fill with approximately 1.8 litres of new oil, take it for a short ride to circulate the oil in the engine, stop the engine, and check the level through the designated window. Top up if necessary.

Watch the video!


by ScegliAuto

More videos