Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replace the Rear Brake Pads on the Honda NC 700X

Model: Honda Nc 700x
Part: Brake pads

Video tutorial

In this tutorial video, you will learn how to remove and replace the rear brake pads on the Honda NC 700X motorcycle. First, place the bike on its centre stand and start unscrewing the bolts securing the brake caliper to remove it from the disc.

Then, extract the old brake pads and clean the caliper of any residual dirt, as shown in the video. At this point, install the new high-quality brake pads in the correct orientation; then refit the caliper onto the disc, securing it with its bolts!


Updated on 21 May 2026 by ScegliAuto


Related tutorials

Instructions for Replacing the Clutch Lever on a Honda NC 700X
Instructions for Replacing the Clutch Lever on a Honda NC 700X
Nc 700x In this video tutorial, you will find instructions to remove and replace the clutch lever on a Honda NC 700X in simple steps. First, remove the rubbe…
How to replace the air filter of the Honda Nc 700X
How to replace the air filter of the Honda Nc 700X
Nc 700x Below are the instructions to remove and replace the air filter of the Honda Nc 700X motorcycle engine. First, place the bike on its centre stand and…
How to check and top up the coolant in the Honda NC 700X
How to check and top up the coolant in the Honda NC 700X
Nc 700x This guide outlines the steps to check the engine coolant level and top it up in the Honda NC 700X. First, place the bike on its stand and begin by r…

How to Set the Time on a Kymco DTX360?

To set the time on a Kymco DTX360, follow these steps. First, turn on the scooter and ensure it is in time display mode on the dashboard. Once you find this mode, press and hold the button for setting the time, located on the scooter's handlebars. After a few seconds, the display will start to flash, indicating that you can now adjust the time. Use the adjustment buttons to increase or decrease the hour until you reach the desired time. When you have set the correct time, press the time setting button again to confirm your selection. The display will stop flashing and the time will be set correctly. Be sure to consult the owner's manual for specific instructions for your Kymco DTX360 model, as the procedure may vary slightly.

Watch the video!


by ScegliAuto

More videos