Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the headlight bulb on the Honda Vision, loosen the screws securing the front fairing of the motorcycle. These screws are located at the bottom of the fairing, just in front of the handlebars. Once the screws are loosened, remove the bolts at the base of the mirrors to detach them as well. After removing the mirrors, you can take off the front fairing to access the interior of the headlamp, where you will find the connector attached to the bulb. Disconnect this by pulling out the bulb and replacing it with a new one.

Updated on 24 May 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

How to Replace the Headlight Bulb on a Honda Vision 110?
How to Replace the Headlight Bulb on a Honda Vision 110?
Vision 110 To replace the headlight bulb on a Honda Vision 110, you need to loosen the screws that secure the front fairing panel. Once the fixing screws are lo…
How to Replace the Headlight Bulb on a Honda Vision 110?
How to Replace the Headlight Bulb on a Honda Vision 110?
Vision 110 You can replace the headlight bulb on the Honda Vision 110 by loosening the screws that secure the front panel of the motorcycle: once the fastening …
How to replace the headlight bulb on the Honda Vision 110?
How to replace the headlight bulb on the Honda Vision 110?
Vision 110 You can replace the headlight bulb on the Honda Vision 110 by unscrewing the screws that secure the front shield of the motorcycle to its housing: on…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos