Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In today's tutorial, you will learn how to install the frame brace and engine guard on the Honda Africa Twin CRF 1000L, following the instructions below. First, place the central stand on your bike and start by unscrewing the pre-installed bolts for the frame brace; then install the brace, securing it properly with the appropriate larger bolts, as shown in the video. At this point, reassemble all the other components previously removed for the installation of the brace, following the tutorial until the end!

Updated on 15 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Air Filter on the Honda Africa Twin?
How to Replace the Air Filter on the Honda Africa Twin?
Africa Twin To replace the air filter on the Honda Africa Twin, loosen the screws securing the protective fairings on the left side of the bike, near the fuel ta…
How do you replace the exhaust pipe of the Honda Africa Twin?
How do you replace the exhaust pipe of the Honda Africa Twin?
Africa Twin To replace the muffler of the Honda Africa Twin, you need to loosen the screws that hold it to its housing on the right side of the motorcycle, near …
How to Replace the Brake Pads on a Honda Africa Twin?
How to Replace the Brake Pads on a Honda Africa Twin?
Africa Twin The procedure for replacing the brake pads on the Honda Africa Twin is the same for both the front and rear wheels. In both cases, loosen the bolts t…

Changing the Oil and Filter on the Kawasaki Versys

Here’s how to change the oil and filter on the Kawasaki Versys. Warm up the engine for a few minutes, place the motorcycle on the centre stand, open the filler cap, and remove the drain plug underneath the engine. Place a catch basin under the oil sump, unscrew the drain plug, and let the oil drain out. Unscrew the oil filter and let all the old oil drain out. Install a new filter and tighten it with the appropriate tool. Pour half a glass of new oil into the filler cap and wait for it to flow out of the drain hole, after which replace the plug. Fill with approximately 1.8 litres of new oil, take it for a short ride to circulate the oil in the engine, stop the engine, and check the level through the designated window. Top up if necessary.

Watch the video!


by ScegliAuto

More videos