Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
The exhaust pipe of the Honda CBR 600RR can be replaced by loosening the screws that secure the exhaust terminal to its housing, which is located near the rear fender of the motorcycle. To remove it, you will need to unscrew all the screws that secure it to its housing and then widen the connecting clamp that joins the exhaust pipe to the exhaust manifold. At this point, you can proceed by disconnecting the old exhaust pipe and installing the new one: the latter can now be properly secured, making sure that everything works.

Posted on 5 May 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust pipe of the Honda CBR 600RR?
How do you replace the exhaust pipe of the Honda CBR 600RR?
Cbr 600 Rr In order to replace the exhaust pipe of the Honda CBR 600RR, you need to loosen the screws that secure the exhaust terminal to its housing: this will…
How do you replace the engine oil of the Honda CBR 600RR?
How do you replace the engine oil of the Honda CBR 600RR?
Cbr 600 Rr The replacement of the motor oil on the Honda CBR 600RR is done by loosening the screws that fix the engine guard plates, located on both sides of th…
How to replace the rear brake pads on the Honda CBR 600RR?
How to replace the rear brake pads on the Honda CBR 600RR?
Cbr 600 Rr To replace the rear brake pads on the Honda CBR 600RR, you need to loosen the bolts that secure the caliper to the brake disc. Once the bolts are loo…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos