Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the muffler of the Honda NHX 110, you need to loosen the screws that secure the exhaust terminal to its housing, which is located near the rear wheel of the motorcycle, on the right side. Once the support screws have been loosened, you can proceed by widening the ring that connects the muffler to the exhaust manifold: in this way, you can completely detach the muffler from its seat in order to insert the new one. The new muffler can be fixed with the appropriate support screws to ensure that everything works properly.

Posted on 10 June 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you remove the rear wheel of the Honda NHX 110?
How do you remove the rear wheel of the Honda NHX 110?
Nhx 110 In order to remove the rear wheel of the Honda NHX 110, you need to loosen the screws that secure the exhaust to its housing, so that the exhaust can…
How to Change the Engine Oil on a Honda NHX 110?
How to Change the Engine Oil on a Honda NHX 110?
Nhx 110 To change the engine oil on a Honda NHX 110, loosen the drain plug of the oil tank located at the central bottom of the bike. Once this plug is remov…
How to Replace the Clutch on the Honda NHX 110
How to Replace the Clutch on the Honda NHX 110
Nhx 110 To replace the clutch on the Honda NHX 110, loosen the screws securing the transmission cover located on the left side of the bike near the rear whee…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos