Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Forza 125
Part: Battery

Today's steps will show you how to disassemble and replace the battery of the Honda Forza 125 scooter, following the instructions below. First, put the scooter on the center stand and start by opening the seat to access the battery; then disconnect both battery terminals (positive and negative), in order to remove it, as shown in the video. At this point, install the appropriate new battery, of the correct type and with the same amperage, making the connection; then check the engine ignition, and finally close the seat!

Posted on 12 June 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust pipe of the Honda Forza 125?
How do you replace the exhaust pipe of the Honda Forza 125?
Forza 125 It will be possible to replace the exhaust of the Honda Forza 125 by loosening the screws that fix the exhaust terminal to its housing: once the corr…
How do you replace the spark plug of the Honda Forza 125?
How do you replace the spark plug of the Honda Forza 125?
Forza 125 In order to replace the spark plug of the Honda Forza 125, you need to loosen the screws that fix the side panel of the motorcycle, removing the foot…
How to Open the Seat of the Honda Forza 125
How to Open the Seat of the Honda Forza 125
Forza 125 This guide provides instructions on how to open the seat of the Honda Forza 125 scooter, equipped with a Keyless system. First, place the scooter on …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos