Do it yourself
Frequently asked questions about cars and motorcycles

Replacing Dipped Beam on Honda Civic

Model: Honda Civic MK 10 - Years: 2016, 2017, 2018, 2019, 2020, 2021
Part: Headlight bulb

See other generations:
Video tutorial

Open the bonnet and place the support rod. Disconnect the connector of the affected rear lamp, then unscrew the bulb from the back (the fitting), as shown in the video, whether it is an LED or halogen. Insert the new bulb by screwing in the fitting, turning clockwise until the three clips are securely in place.

Reconnect the main connector that was initially removed to the new bulb fitting, and you're done. The procedure is the same for both front dipped beams.

Start the car to check its operation.


Updated on 9 April 2026 by ScegliAuto


Related tutorials

Honda Civic (2016-2021 / MK 10) Today, let's see how to replace the dipped beam (H11) and main beam (HB3) bulbs on a tenth-generation Honda Civic, produced from 2016 to 2021. Start …
Honda Civic (2016-2021 / MK 10) Start by pressing the rear button of the key for your Honda Civic to extract the physical emergency key. Next, using the emergency key as a lever, pr…
Honda Civic (2016-2021 / MK 10) On the Honda Civic, resetting the Tyre Pressure Monitoring System (TPMS) is done with the vehicle stationary, with pressures adjusted to the values i…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

Resetting the Service Light on the Mitsubishi Canter

When it is necessary to change the engine oil of the Mitsubishi Canter, a warning on the dashboard alerts us to this requirement. Once this maintenance task is completed, you must reset the control system. Sit in the driver's seat and turn on the instrument panel. Without starting the engine, press and hold the accelerator pedal for twenty seconds. After this time interval, while still holding the accelerator pedal, pump the brake pedal six times. Once done, the warning on the instrument panel will turn off, confirming the reset.

Watch the video!


by ScegliAuto

More videos