Do it yourself
Frequently asked questions about cars and motorcycles

Replacement of Front Brake Discs and Pads

Model: Honda CR-V MK 2 - Years 2002-2007
Part: Brake rotors

The necessary tools for the operation are: torque wrench, ratchet spanner, Allen key, hammer, and wire brush. Remove the retaining springs from the drum cover and, using a ratchet spanner, completely remove the bolts. Take out the drums and pads. Remove the drum supports. Using the Allen key, remove the screws from the disc and the disc itself. Clean the support thoroughly with the wire brush and install the new disc. Tighten the fixing screws securely. Refit the drum supports using the torque wrench. Install the new pads and drums. Reposition the cover springs and tighten the bolts. Reattach the clips to the brake pipe. Ensure that the pads contact the disc.

Updated on 8 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Honda CR-V (2007-2012 / MK 3) The following guide illustrates, step by step, how to replace the brake discs on your car in the best possible way. The braking system is of primary …
Honda CR-V (2007-2012 / MK 3) Lift the vehicle on suitable car stands and remove the front wheel; then detach the fixing pins of the brake calliper and its support; unscrew the fi…
Honda CR-V (2002-2007 / MK 2) Lift the vehicle on suitable axle stands and remove the rear wheel; then proceed to unscrew the fastening pins of the brake caliper located at the re…

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos