Oil and Engine Filter Change on Husaberg FE 390

Model: Husaberg Fe 390
Part: Engine oil

This video is currently unavailable

Remove the bash plate, take off the upper filler cap and then the lower drain plug (clean the latter as it will have residues). Collect the used oil in a container.

When it seems that everything has drained, turn the ignition on without starting the engine. This will ensure that any last residue of old oil comes out of its container.

Remove the two Torx screws that protect the oil filter. From this, which you can now pull out with a small flat screwdriver (or a piece of wire), more oil will obviously come out, so keep the container underneath.

Proceed in reverse for the installation of the new filter, close the engine oil drain hole, insert the new lubricant through the upper hole and close this as well.

Updated on 29 March 2026 by ScegliAuto

How to replace the clutch lever on the Sherco SEF 300?

To replace the clutch lever on the Sherco SEF 300, you need to loosen the screws that secure the lever to its housing on the left side of the handlebars. Once these screws are loosened, you can unscrew the nut at the base of the lever to disconnect the clutch cable attached to the corresponding lever. Once the cable is detached, the lever can be removed from its housing and replaced with a new spare part; after installation, ensure that it functions correctly.

Watch the video!

by ScegliAuto

Oil and Engine Filter Change on Husaberg FE 390

Related tutorials

How to replace the clutch lever on the Sherco SEF 300?

More videos