Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Tyres on the Husaberg FE 450

Model: Husaberg Fe 450
Part: Tires

Video tutorial

In this guide, follow the instructions to remove and replace the tyres on the Husaberg FE 450 enduro bike. First, place the bike on a stand and lift the wheel off the ground; then, undo the bolts securing the brake caliper to remove it, as shown in the video.

Next, unscrew the central axle of the wheel, removing the tyre from the rim (deflating it and using levers); then install the new tyre, ensuring it has the correct dimensions, following the video tutorial to the end!


Updated on 7 July 2026 by ScegliAuto


Related tutorials

How to Replace the Spark Plug on the Husaberg FE 450?
How to Replace the Spark Plug on the Husaberg FE 450?
Fe 450 To replace the spark plug on the Husaberg FE 450, locate the coil on the right side of the bike, just behind the radiator: once the coil is disconnec…
How to Replace the Camshaft on the Husaberg FE 450?
How to Replace the Camshaft on the Husaberg FE 450?
Fe 450 To replace the camshaft on the Husaberg FE 450, loosen the screws that secure the side covers of the bike, which protect the engine block on the left…
How to Replace the Clutch Cover on Husaberg FE 450
How to Replace the Clutch Cover on Husaberg FE 450
Fe 450 In this video, see how to disassemble and replace the clutch cover on a Husaberg FE 450 and 570 enduro bike in simple, quick steps. First, position t…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos