Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil on a Husaberg FE 450

Model: Husaberg Fe 450
Part: Engine oil

Video tutorial

To change the engine oil on the Husaberg 450 FE, loosen the drain plug located at the bottom centre of the bike's oil sump. Once the plug is removed, collect all the oil in a suitably positioned container.

This way, you can close the plug when the drainage is complete, then remove and replace the oil filter located in this position. After removal, top up the oil by pouring it through the breather located on the right side of the bike.


Updated on 30 September 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil of a Husaberg FE 450?
How to Change the Engine Oil of a Husaberg FE 450?
Fe 450 To change the engine oil of the Husaberg FE 450, loosen the drain plug located at the bottom of the vehicle. Once this plug is removed, you can colle…
How to Replace the Spark Plug on the Husaberg FE 450?
How to Replace the Spark Plug on the Husaberg FE 450?
Fe 450 To replace the spark plug on the Husaberg FE 450, locate the coil on the right side of the bike, just behind the radiator: once the coil is disconnec…
How to Replace the Clutch on the Husaberg FE 450
How to Replace the Clutch on the Husaberg FE 450
Fe 450 In today's video, we will go through the steps to dismantle and replace the clutch discs on the Husaberg FE 450 enduro bike, following the instructio…

How to Change the Engine Oil on a BMW R1200T?

To change the engine oil on a BMW R1200T, follow these steps. Ensure the bike is on a level surface and the engine is warm but not too hot. Remove the oil filler cap and the oil drain plug, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew it to fully drain the used oil. Once drained, remove and replace the oil filter, ensuring to clean the mounting surface thoroughly. Install the new filter and screw the oil drain plug back in. Fill the engine with new oil through the filler cap until reaching the recommended amount, checking the level with the dipstick if necessary. Secure both caps tightly. Start the engine for a few minutes to circulate the new oil, then turn it off, and the replacement is complete.

Watch the video!


by ScegliAuto

More videos