Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
It will be possible to replace the exhaust installed on the Husqvarna Norden 901 by unscrewing the screws that fix the cover on the side of the corresponding fender, near the rear wheel: once the screws have been loosened, it will be possible to widen the clamp located between the terminal and the exhaust manifold. Once the old exhaust has been removed from its seat, it will be possible to position the new one, fixing it to the respective supports and connecting it to its manifold: once the connection has been made, it can be verified that everything is functioning properly.

Posted on 16 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust of the Husqvarna Norden 901?
How do you replace the exhaust of the Husqvarna Norden 901?
Norden 901 To replace the muffler of the Husqvarna Norden 901, you need to loosen the screws that secure the panel on the side of the vehicle, near the rear whe…
How do you replace the exhaust pipe of the Husqvarna Norden 901?
How do you replace the exhaust pipe of the Husqvarna Norden 901?
Norden 901 The exhaust pipe installed on the Husqvarna Norden 901 can be replaced by loosening the screws that secure the cover on the side of the rear wheel fe…
How do you replace the exhaust pipe of the Husqvarna Norden 901?
How do you replace the exhaust pipe of the Husqvarna Norden 901?
Norden 901 The exhaust pipe installed on the Husqvarna Norden 901 can be removed from its seat by loosening the screws that secure the panel located on the side…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos