Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today's procedure will show us how to perform the routine maintenance service by replacing the engine oil and oil filter on the Husqvarna FE 450 enduro motorcycle. First, we place the motorcycle on the stand and begin by removing the metal engine cover. Next, we unscrew the oil drain bolt found on the oil pan, allowing it to drain into a container for about ten minutes, as shown in the video. Now, we remove the filter cover to take out and replace the oil filter cartridge; all that's left is to top up with the new engine oil!

Posted on 1 January 2026 by ScegliAuto

Video tutorial

Related tutorials

Change the Engine Oil and Oil Filter of the Husqvarna FE 450
Change the Engine Oil and Oil Filter of the Husqvarna FE 450
Fe 450 Today, we will go through the necessary instructions to perform the routine maintenance service by changing the engine oil and oil filter of the Husq…
Engine Oil and Oil Filter Replacement for the Husqvarna FE 450
Engine Oil and Oil Filter Replacement for the Husqvarna FE 450
Fe 450 Below are the instructions that will allow you to carry out the routine maintenance service by replacing the engine oil and oil filter on the Husqvar…
How to perform service on the Husqvarna FE 450
How to perform service on the Husqvarna FE 450
Fe 450 In this brief and simple guide, discover the instructions for performing routine maintenance on the Husqvarna FE 450 by replacing the engine oil, air…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos