Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Husqvarna Fe 350
Part:

To replace the fuel tank on the Husqvarna FE 350, loosen all the screws securing the seat of the motorcycle, which must be removed to access the underlying components. The tank will only be accessible after removing the two side panels at the front. Then, remove the tank from its housing by unscrewing the screws that hold it in place and disconnecting all the various hoses and connectors. This will allow you to install the new replacement part; after installation, reassemble all the components that were previously removed.

Updated on 22 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replace the Coolant in the Husqvarna FE 350
Replace the Coolant in the Husqvarna FE 350
Fe 350 Today, we will see in this brief and simple guide how to bleed and replace the coolant in the Husqvarna FE 350, following the instructions below. Fir…
How to Replace the Rear Mudguard of the Husqvarna FE 350?
How to Replace the Rear Mudguard of the Husqvarna FE 350?
Fe 350 To remove the rear mudguard of the Husqvarna FE 350, loosen the bolts securing the seat to its housing so that it can be completely removed. After re…
How to Reset the Service on the Husqvarna FE 350?
How to Reset the Service on the Husqvarna FE 350?
Fe 350 In this tutorial, you will see how to reset the service on the Husqvarna FE 350, a very simple and quick operation. Before proceeding, ensure you hav…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos