Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Renegade
    4. : Replacement diesel filter on Jeep Renegade

Jeep Renegade - Video tutorial

Model: Jeep Renegade BU, MK 1, 520 - Years 2014-2023
Part: Diesel filter
Operation: Replacement diesel filter on Jeep Renegade

Lift the hood and put on the special support rod. For safety, you could disconnect the negative pole of the battery. Disconnect the first connector and the duct above the diesel filter by pushing the white tab with a flat screwdriver. Disconnect the cable that always reaches the top of the filter, as shown in the video. As you did with the first connector, disconnect the second duct in the same way, then unscrew the two side screws and extract the filter compartment from its seat. Unscrew all the screws that secure the filter compartment cover and once it is open, remove the filter and insert the new one.


Posted on 23 January 2024 by ScegliAuto



Jeep Renegade cabin filter replacement
Jeep Renegade (2014-2023 / BU, MK 1, 520) In this video guide we will see how to remove and replace the cabin filter of a Jeep Renegade. First we get on board the car, on the passenger side,
How to replace the fuel filter in the Jeep Renegade?
Jeep Renegade (2014-2023 / BU, MK 1, 520) In this tutorial, we can see how to replace the fuel filter in the Jeep Renegade. For this operation, we will need to lift the car on a bridge or wit
How to replace the front brake pads in a Jeep Renegade 1.6 diesel 120 hp?
Jeep Renegade (2014-2023 / BU, MK 1, 520) If you need to remove and replace the front brake pads of your Jeep Renegade 1.6 diesel 120 hp, just watch this video tutorial and carefully follow a

    Frequently Asked Questions

    • Jeep Renegade 2014-2023 - Where is the diesel filter located in the Jeep Renegade? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos