Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Kawasaki
    3. : Ninja Zx6r
To change the motor oil of the Kawasaki Ninja ZX6R, start by lifting the bike using a center stand or side stand to ensure a stable position. Remove the oil drain plug located under the engine and let the used oil drain into a suitable container. Once the oil is completely drained, screw the drain plug back in and make sure it is tightly sealed. Then, locate and remove the oil fill cap on the top of the engine. Slowly pour the new oil through the fill spout using a funnel to prevent spills. After filling the engine with the appropriate amount of oil, reattach the fill cap. Start the engine and let it run for a few minutes to allow the oil to circulate. Turn off the engine and check for any leaks. Check the oil level again, adding more if necessary. Make sure to dispose of the used oil in accordance with environmental regulations.

Posted on 16 July 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Grips on a Kawasaki Ninja ZX6R?
How to Replace the Grips on a Kawasaki Ninja ZX6R?
Ninja Zx 6r To replace the grips on a Kawasaki Ninja ZX6R, loosen the central screw that secures the weight located at the end of each grip. Once the weight is r…
Removing the Seat of a Kawasaki Ninja ZX6R 636
Removing the Seat of a Kawasaki Ninja ZX6R 636
Ninja 636 In this video, we will see how to remove the seat of a Kawasaki Ninja ZX6R 636 in simple steps. First, unscrew the side plastic screw with a screwdri…
How to change the motor oil of a Kawasaki Ninja ZX-6R?
How to change the motor oil of a Kawasaki Ninja ZX-6R?
Ninja Zx 6r To perform an oil change on a Kawasaki Ninja ZX-6R, start by placing the motorcycle on a flat and stable surface. Then, use the center stand to lift …

How to Replace or Top Up the Engine Oil of the Honda NSC 110 Vision

This guide will show you how to carry out the routine maintenance service by replacing the engine oil and air filter of the Honda NSC 110 Vision scooter. First, place your scooter on the centre stand and start unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small metal oil filter as shown in the video. Now pour in the new engine oil, checking the level with the dipstick; finally, replace the air filter by unscrewing the screws of the cover to remove it!

Watch the video!


by ScegliAuto

More videos