Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kawasaki Ninja 650
Part: Clutch

In order to replace the clutch of the Kawasaki Ninja 650, you will need to loosen the screws that secure the cover of the component, located on the right side of the bike in the central lower area. Once the cover is removed, you can loosen the screws underneath that secure the clutch discs in order to extract them. At this point, you can insert the new replacement parts and secure them with the previously removed screws, then cover everything with the cover to ensure that everything is working properly.

Posted on 24 September 2025 by ScegliAuto

Video tutorial

Related tutorials

How to replace the clutch cable on the Kawasaki Ninja 650R?
Ninja 650 To replace the clutch cable on the Kawasaki Ninja 650R, you need to remove the side fairing covering the cable by unscrewing the relevant bolt. To fr…
How to Replace the Exhaust on a Kawasaki Ninja 650?
How to Replace the Exhaust on a Kawasaki Ninja 650?
Ninja 650 To replace the exhaust on a Kawasaki Ninja 650, loosen the screws that secure the exhaust end can to its housing on the right side of the rear mudgua…
How to Replace the Exhaust on a Kawasaki Ninja 650
How to Replace the Exhaust on a Kawasaki Ninja 650
Ninja 650 To replace the exhaust fitted on the Kawasaki Ninja 650, loosen the screws located at the exhaust terminal supports. Once the exhaust is fully releas…

Float Replacement on Piaggio X9

To replace the float on the Piaggio X9 250, you need to disassemble it completely. Start by removing the two bolts from the underseat compartment and disconnect the rear light connector. Inside, there are two more screws to remove, two side bolts, and two at the bottom of the bodywork. On the lower plastic where the exhaust is, there is another bolt to remove and another underneath. That piece slides back and can be removed by pulling it hard. Then, there are three large support bolts for the footrest and three smaller ones. Remove the three bolts from the carburettor airbox and disconnect it, including all the carburettor fuel hoses. Next, remove the bolt near the glove compartment to take off the handle. There will be two more small bolts. At this point, by removing the bolt under the headlight, you can also take off the left fairing. Finish by removing the three Allen screws on top. Disconnect the bulbs by removing the headlight cover. Slide the seat back by disconnecting the connector. Remove the three bolts from the cover. Remove the four screws holding the fuel cap (you must also remove the cap gasket, otherwise it won't come off). Remove the two bolts holding the rest of the footrest (as previously mentioned). This exposes the part you are interested in. Also, open the top by removing the underseat cover plastic. Loosen the throttle and deceleration cable. Remove the bolt securing the diaphragm, loosen the clamps on the manifolds, and disconnect the fuel and air hoses. Now the carburettor can be removed. All that remains is to unscrew the four bolts of the float and change the float chamber, which must not have any play but stay firmly in place. Now, all that is left is to reassemble everything in reverse order of disassembly!

Watch the video!


by ScegliAuto

More videos