Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kawasaki Ninja 650
Part: Clutch

To replace the clutch cable on the Kawasaki Ninja 650R, you need to remove the side fairing covering the cable by unscrewing the relevant bolt. To free the cable, loosen the two nuts shown in the video: this can then be pulled out, and the pieces securing it to the bike must be removed. These pieces will be useful when fitting the new cable, which should be connected at one end to the clutch and at the other to the corresponding lever. Finally, reattach the previously removed fairing.

Updated on 9 May 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

How to set the time on a Kawasaki Ninja 650R?
How to set the time on a Kawasaki Ninja 650R?
Ninja 650 In this tutorial, you will see how to set the time on a Kawasaki Ninja 650R, a very simple and quick operation, for example, after disconnecting the …
How to Replace the Front Headlight Bulbs on the Kawasaki Ninja 650R?
How to Replace the Front Headlight Bulbs on the Kawasaki Ninja 650R?
Ninja 650 In this tutorial, we will see how to replace the front headlight bulbs on the Kawasaki Ninja 650R, a very simple and quick operation. First, ensure t…
How to Replace the Front Brake Pads on a Kawasaki Ninja 650R?
How to Replace the Front Brake Pads on a Kawasaki Ninja 650R?
Ninja 650 To replace the front brake pads on a Kawasaki Ninja 650R, loosen the screws that secure the brake caliper to the top of the corresponding disc. Once …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos