Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the motor oil in the Kawasaki Ninja 500?

Model: Kawasaki Ninja 500
Part: Engine oil

Video tutorial

In this tutorial we can see how to replace the motor oil in the Kawasaki Ninja 500, a very simple and fast operation. First of all, we wait for the engine to be cool enough, then we remove both lower side fairings and place a container underneath the motorcycle.

We then locate the drain hole bolt, unscrew it using a 17mm socket wrench and let all the oil in the system drain out. At this point, all that's left is to unscrew the old filter, tighten both the replacement and the bolt, and pour the necessary amount of oil through the appropriate hole.


Posted on 24 October 2025 by ScegliAuto


Related tutorials

How to change the engine oil and oil filter on the Kawasaki Ninja 500
How to change the engine oil and oil filter on the Kawasaki Ninja 500
Ninja 500 Below are the instructions that will allow you to perform the routine maintenance service by changing the engine oil and oil filter on the Kawasaki N…
How to Change the Engine Oil on a Kawasaki Ninja 500?
How to Change the Engine Oil on a Kawasaki Ninja 500?
Ninja 500 This tutorial shows how to change the engine oil on a Kawasaki Ninja 500, a simple and quick task. First, wait for the engine to cool down sufficient…
How to Change the Engine Oil in the Kawasaki Ninja 500?
How to Change the Engine Oil in the Kawasaki Ninja 500?
Ninja 500 This tutorial shows how to change the engine oil in the Kawasaki Ninja 500, a very simple and quick operation. First, ensure the engine is cool enoug…

How to Replace the Rev Sensor on a Benelli TNT 600

This guide provides instructions on how to remove and replace the engine rev sensor on a Benelli TNT 600 motorcycle by following these simple steps. First, place your motorcycle on a stand and disconnect the electrical connector of the rev sensor located on the left side engine cover; then use a socket spanner with an extension to unscrew and remove the bolt, as shown in the video. At this point, remove and replace the rev sensor, installing the original part to ensure proper functioning, applying the reverse procedure for reassembly!

Watch the video!


by ScegliAuto

More videos