Do it yourself
Frequently asked questions about cars and motorcycles

Model: Keeway Txm 125
Part: Light bulb

To replace the headlight bulb on the Keeway TXM 125, you need to unscrew the bolts located inside the front fairing so that it can be detached. After removing the front fairing, you can open the protective cap at the back of the headlight to access the bulb. This can be pulled out of its housing and disconnected from its connector. The new bulb should be connected to the connector and reinserted into the housing. Finally, you can replace the protective cap and reattach the front fairing with the corresponding bolts.

Updated on 25 April 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Txm 125 To replace the front headlamp bulb on the Keeway TXM 125, loosen all the screws located near the fork and on the inside of the front fairing, as indi…
Txm 125 To change the engine oil of the Keeway TXM 125, loosen the drain plug located at the central lower part of the bike. Once removed, collect the oil in…
Txm 125 To replace the exhaust on the Keeway TXM 125, remove the side plastics of the bike by loosening the three screws that secure them. Once the plastics …

Dismantling and Replacing the Front Cowl of the Kymco Super8 150

Follow these simple steps to dismantle and replace the front cowl of the Kymco Super 8 150 scooter. First, place the scooter on the centre stand and start unscrewing and removing the screws located at the rear of the front cowl; then unscrew the additional screws found underneath, first removing the cover situated above the front headlamp and then the rest of the remaining cowl, as shown in the video. At this point, install the new front cowls, securing all components correctly, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos