Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the air filter on the Keeway K-Blade 125, loosen the bolts securing the cover near the rear wheel, just above the clutch cover. Once the cover is removed, extract the old filter from inside and insert a new one. After fitting the new filter, close the cover and secure it with the appropriate bolts. Once the installation is complete, check that everything is functioning perfectly.

Updated on 8 May 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

How to Replace the Air Filter on the Keeway K-Blade 125?
How to Replace the Air Filter on the Keeway K-Blade 125?
Kblade 125 .. To replace the air filter on the Keeway K-Blade 125, loosen the screws securing the cover containing the air filter, located on the left side of.. …
How to Replace the Air Filter on the Keeway K-Blade 125?
How to Replace the Air Filter on the Keeway K-Blade 125?
Kblade 125 .. To replace the air filter on the Keeway K-Blade 125, loosen the screws securing the cover that contains the air filter, located on the right side.. …
How to Replace the Front Brake Pads on a Keeway K-Blade 125
How to Replace the Front Brake Pads on a Keeway K-Blade 125
Kblade 125 To replace the front brake pads on the Keeway K-Blade, remove the central pin that secures the front wheel to the swingarm, allowing the wheel to be …

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos