Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the rear lamp bulb on a Keeway Superlight 125, loosen the screws securing the lamp and the corresponding chrome part surrounding it. Once these two components are loosened, detach the optical unit from its housing to access the bulb inside. When the old bulb is removed from its socket, insert the new one and connect the corresponding connector. Finally, reposition the lamp in its housing and secure it with the screws removed earlier.

Updated on 17 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Start a Keeway Superlight 125
How to Start a Keeway Superlight 125
Superlight 125 Start by sitting on the rider's seat of your Keeway Superlight 125. Next, insert the key into the ignition switch and turn the key to activate the da…
How to replace the headlight bulb on the Keeway Superlight 125
How to replace the headlight bulb on the Keeway Superlight 125
Superlight 125 This guide shows how to disassemble and replace the headlight bulb on the Keeway Superlight 125 motorcycle. First, put the bike on its centre stand a…
How to replace the headlight bulb on the Keeway Superlight 125?
How to replace the headlight bulb on the Keeway Superlight 125?
Superlight 125 To replace the headlight bulb on the Keeway Superlight 125, loosen the screws around the lens of the headlight so that it can be removed from its hou…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos