Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today's guide will show you the main steps for removing and replacing the battery of the Keeway Superlight 200 motorcycle. First, place the bike on its stand and start by removing the rider's seat; you will find the battery on the side of the bike, where you will need to remove its cover to access it. At this point, disconnect both battery terminals (positive and negative); remove the battery from its compartment and replace it with the new original one, reconnecting the electrical connections and finally refitting the cover and the seat!

Updated on 27 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Throttle Cable on a Keeway Superlight 200
How to Replace the Throttle Cable on a Keeway Superlight 200
Superlight 200 This guide provides the main instructions on how to remove and replace the throttle cable on a Keeway Superlight 200 motorcycle. First, place the mot…
How do you replace the engine oil of the Keeway Superlight 200?
How do you replace the engine oil of the Keeway Superlight 200?
Superlight 200 To replace the engine oil of the Keeway Superlight 200, you need to loosen the drain plug located in the central lower part of the vehicle: once this…
How to Replace the Throttle Cable on the Keeway Superlight 200
How to Replace the Throttle Cable on the Keeway Superlight 200
Superlight 200 This guide provides instructions for removing and replacing the throttle cable on the Keeway Superlight 200 motorcycle. First, place the motorcycle o…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos