Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Key Fob Battery of the KTM 1290 Super Adventure R?

Model: Ktm 1290 Super Adventure R
Part: Key

Video tutorial

In this tutorial, see how to replace the battery of the key fob for the KTM 1290 Super Adventure R, a very simple and quick operation. You will need a small flat screwdriver and a replacement battery of type CR2032. First, pry along the perimeter of the rear cover using the screwdriver, then completely separate it and also open the circular cap. Next, remove the old battery, insert the replacement while ensuring the correct polarity, and reassemble everything by following the reverse procedure.


Posted on 23 June 2026 by ScegliAuto


Related tutorials

How do you replace the battery of the KTM 1290 Super Adventure R?
How do you replace the battery of the KTM 1290 Super Adventure R?
1290 Super Adventure R In order to replace the battery of the KTM 1290 Super Adventure R, you need to loosen the screws that secure the motorcycle seat to its housing: thes…
How to reset the service on the KTM 1290 Super Adventure R?
How to reset the service on the KTM 1290 Super Adventure R?
1290 Super Adventure R In this tutorial, we will see how to reset the service on the KTM 1290 Super Adventure R, a very simple and quick operation that should be done only …
How to reset the service light on the KTM 1290 Super Adventure R?
How to reset the service light on the KTM 1290 Super Adventure R?
1290 Super Adventure R This tutorial shows how to reset the service light on the KTM 1290 Super Adventure R, a very simple and quick operation to be performed only after co…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos