Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Antifreeze in a KTM Duke 390

Model: Ktm Duke 390
Part: Antifreeze coolant

Video tutorial

In this brief and simple guide, follow these steps to bleed and replace the coolant in a KTM Duke 390. First, place your bike on a stand and unscrew the bleed screw located on the water pump casing, allowing the old fluid to drain into a container for about ten minutes.

Then, unscrew the radiator cap as shown in the video.

Now, top up with new fluid suitable for your radiator, filling until you reach the maximum mark!


Updated on 17 July 2026 by ScegliAuto


Related tutorials

How to Replace the Coolant in a KTM Duke 390
How to Replace the Coolant in a KTM Duke 390
Duke 390 In this short and simple guide, discover how to replace the coolant in the KTM Duke 390 motorcycle. First, place your bike on a stand and start by un…
How to Reset the "Service" Light on a KTM Duke 390
How to Reset the "Service" Light on a KTM Duke 390
Duke 390 Before starting, the regular service should already have been performed, and then you need to sit on the rider's seat of your KTM Duke 390. Start by …
How to Replace the Coolant on the KTM Duke 390
How to Replace the Coolant on the KTM Duke 390
Duke 390 In this video, you will see how to replace the coolant or antifreeze on a KTM Duke 390, following the instructions below. First, remove the side plas…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos