Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Below are the instructions that will allow you to remove and replace the front brake pads on a KTM Super Duke 1290 R motorcycle. First, place the motorcycle on a stand and begin by unscrewing the two fixing screws of the front brake caliper to remove it from the disc. Then, leverage inside the caliper to retract the piston, allowing you to remove the old brake pads, as shown in the video. Now, clean the caliper of any residual dirt and install the new original pads or high-quality alternatives; finally, refit the brake caliper!

Updated on 16 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Brake Pads on the KTM Super Duke 1290?
How to Replace the Rear Brake Pads on the KTM Super Duke 1290?
Super Duke 1290 R To replace the rear brake pads on the KTM Super Duke 1290, you need to loosen the central nut that secures the brake caliper to the disc: this will a…
Replacing rear brake pads on KTM SuperDuke 1290 R
Replacing rear brake pads on KTM SuperDuke 1290 R
Super Duke 1290 R In today's video, you will see how to remove and replace the rear brake pads on a KTM SuperDuke 1290 R. First, remove the retaining clip of the pads …
How to Reset the Service Light on a KTM Super Duke 1290 R
How to Reset the Service Light on a KTM Super Duke 1290 R
Super Duke 1290 R This tutorial shows how to reset the service light on a KTM Super Duke 1290 R, a very simple and quick operation. Before proceeding, ensure that you …

How to Replace the Front Headlight on the BMW F800GS

In this tutorial, you will see how to replace the front headlight on the BMW F800GS, an extremely simple and quick operation. First, ensure the key is not inserted for safety, then locate the power connector at the back of the headlamp and disconnect it by pressing the clip. Next, unscrew the two side bolts using a Torx T40 key, grasp the headlight and pull it away from the support. At this point, you can insert the replacement, tighten the two bolts, and reconnect the power connector.

Watch the video!


by ScegliAuto

More videos